The cylinder should not be worn out on a 99 car unless you were using a very heavy key chain. I would just replace the ignition switch if the cylinder works OK. You also might try some Graphite lube on the cylinder.
how DO YOU REMOVE AN IGNITION CYLINDER FROM A MALIBU CHEVROLET 2000
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
The tumblers in the key cylinder have most likely become stuck in the wrong position and you will have to replace the ignition key cylinder.
Disconnect the negative battery cable and remove the steering wheel. Turn off windshield wiper and disconnect the wiring. Insert the key into the cognition and turn the switch to a locked position. Depress the retaining pin and remove the cylinder. Enter the old cylinder into the new ignition.
Maybe your steering wheel it's keeping the ignition cylinder to turn, so move the steering wheel and at the same time try to turn the key. Maybe you need to replace the ignition cylinder key lock
how DO YOU REMOVE AN IGNITION CYLINDER FROM A MALIBU CHEVROLET 2000
please give instructions on replacing the ignition switch on my 99 Malibu
can I switch ignition cylinder with a different ignition cylinder w/key in a 2004 chevy Malibu without having to use a passcode
How I can replace ignition switch cylinder from Isuzu Rodeo?.
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder
you are going to have to take the whole key cylinder out.
The ignition lock switch is found under the steering column on a 2004 Honda Civic. Remove the steering column and ignition switch. Loosen the mounting screws that hold the cylinder in place. Pull and replace the lock cylinder.
The tumblers in the key cylinder have most likely become stuck in the wrong position and you will have to replace the ignition key cylinder.
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.
You do not need a key to replace the ignition switch.