Connect a known good spark plug to a spark plug wire and ground the threads to the engine while cranking. If there's spark to the electrode you know the coil is good and it's sending current through the wire.
1974 c65 chev. w/ 366 , need spark plugs
Ford uses Motorcraft Spark plugs on all there vehicles.
One at a time
what is the calibration of the spark plugs in a forklift clark 4 cyl. 1974
Four, one per cylinder.
YES.
No it will not, Not even close.
If you KNOW that all the plug wires are on the cap and spark plugs RIGHT and that the engine is in time then remove the valve covers and start the engine back up and make SURE that ALL the valve springs are moveing up and down while the engine is idleing. Be sure to check them close. If they are not all moveing then you need to REPLACE the cam and lifters.
If you buy the spark plugs the gap should already be preset to fit your specific vehicle. The gap is 0.032 in.Ê
No it does not, Unless someone has MODIFYED it.
If it's points or a Dyna S ignition you set the plugs at 28, other wise you set the plugs between 38 - 40
A 10W-30 or 10W-40 should be fine.