answersLogoWhite

0

You could remove them one at a time and measure the resistance with a ohm meter. A good ignition wire should read between 3000 and 10000 ohms per foot.

This answer sounds like a good technical approach. Another way that requires less equipment and knowledge is sort of a backyard mechanic's simple rule of thumb. Go out to the car and start it while it is dark out. Open the hood and look at the engine for any random arching or flashing of light in the area where the wires would be. This flashing appears because the insulation has worn and power is "leaking" along the length of the wire causing ignition problems. If your car is at or near the mileage that your manufacturer has stated to change spark plugs you probably should go ahead and do so anyway.

If the mileage is at or around 100,000miles it is probably time for a plug/wire replacement anyway for modern automobiles and sooner for those vehicles that are 10 or 20 years older. I suggest replacing the coil too as this can be worn to a point of needing replacement. The only reservation I would have is for those vehicles having not central coil but a power pack on each plug. The expense to replace these could require a more technical approach like the one suggested at the beginning of this thread.

Getting a vehicle repair manual like Haynes Publishing or others (Used to be Chilton too) is pretty cheap (around $20 - or check with Public Library) and can provide a more step by step process to arrive and an educated decision. Remember to be careful not to touch wires while the car is running. Only new wires can ensure the electrical current running through them will not escape and bite you. If you must touch the wires while the car is running (like on older cars where you have to turn the distributor to time the engine) use a rag or something to insulate you from the juice in the wires.

User Avatar

Wiki User

∙ 16y ago
User Avatar

What else can I help you with?

Related Questions

What is the plug wire placement on 4.3Lt?

need to know the year.


What spark plug goes to which plug wire on a 1998 Chevy truck?

Need to know what engine you have.


How do you change a four wire plug to a three wire plug?

I need a lot more information. I don't know what you mean by four wire plug. What does it look like, what was it used for? What three wire plug are you installing, what does it look like, what is it used for. What color ore the wires?


What is spark plug wire routing for a 1985 Pontiac?

Need to know what size engine it has.


Which spark plug wire gose to which spark plug?

To answer your question we need to know what year car and which engine the car has. Please ask again with that information .


I have a1982 Chevrolet 305 and wan't to know were does the longies plug wire go?

to the furtherest plug! Plug #1 is probably the longest wire


New fuel pump but still not starting?

You did not say what year, engine size are what you are working on. NEED TO KNOW. Do you have spark at the plug wire were it hooks to the spark plug.


Code miss fire on cylinder 6?

Could be a bad plug wire,spark plug,coil. Really need to know what your working on and the engine size.


Will a 2 pole wire work with a 3 pole plug?

A 2-pole wire will not work on a 3-pole plug. You will need to use a 3-pole wire on a 3-pole plug.


What type of spark plug wire do you need for 83 Honda xl250?

any solid core plug wire should work


Is 1 plug first wire right of center looking from radiator ON DISTRIBITOR CAP?

Need to know what year, what make and what engine.


You need to know where each plug wire goes from cap to motor?

They go from the cap to the spark plugs. Replace one at a time to avoid confusion.