Want this question answered?
If the lid formed a seal, it should sag from the outside pressure.
run lid over hot water and open with a cloth over lid.
Approximately 7.5ml will fit inside of a lid from a soda. This is the lid that keeps the bottle of soda closed. It would only take about 4 lids to make an ounce.
Harriet should ask several senior citizens to evaluate whether her jar lid design is easier to use than a traditional jar lid.
I am going to ignore your poor grammar skills on this one, but here is the answer. You first start on a low power to locate the specimen or bacteria. Then you switch to a high power to get a better look at it. Hope this helps.
open trunk lid and locate the trunk light switch.push switch to see if light goes off. if light does not go off, replace switch. if light does go off, adjust switch to where trunk lid operates switch when trunk is closed
The trunk lid is open or the ajar switch has malfunctioned.The trunk lid is open or the ajar switch has malfunctioned.
There is a safety switch on all washers and dryers to stop accidents. It turns off power when the lid is raised. Most likely the switch needs adjustment if the machine goes into normal cycle when you lift the lid. Locate switch and adjust to make it less sensitive. First turn power off, remove plug.
If you are sure the lid safety switch is at fault do not bother with it, they are cheaper and easier to replace
The trunk lid is open or the trunk ajar switch has malfunctionedThe trunk lid is open or the trunk ajar switch has malfunctioned
no such switch.
If your washing machine will agitate, but refuses to spin out, you more than likely have a bad lid switch. A lid switch, when working properly, tells the washing machine when the lid is closed, thus allowing the washer to spin out. A faulty switch will signal that the lid is still open, even though it isn't, and the water will not spin out. Repairing a lid switch is easy for the average do-it-yourself person with some instructions from internet sources, especially videos. These switches will run anywhere from $20-$60 depending on the machine and are found at your local appliance repair centers.
there is a small magnet on lid and magnetic switch on laptopbase
Look for switch on floor
If a Maytag washer fills with water but does not agitate it could a problem with the switch in the lid. There is a switch that locks the lid down during agitation and spinning. The magnet could be defective.
its on the distributor
Locate the switch and turn it on.