0
There are many ways to do this and some may or may not pertain to your engine. 1. increase the chamber volume by grinding or machining, doing valve work ect. 2. raise up the head by adding thicker head gasket 3. raise up the cylinder if the cylinders are removable and has a gasket below it. 4. install lower compression pistons 5. remove material from piston top (this will weaken the piston top)
What else can I help you with?
Do i have to use a water cooled nitro motor for nitro boat?
no you just need air flow
How many RPM in RC plane?
it all depends on what electric motor,nitro or gas engine you have and the size and mixture of nitro you have (if your using a nitro engine), and for the electric motors it depends on what size motor and how many kv it has and what size and type of battery your using.
Where is blower motor resister on a dodge Nitro?
behind the glove box
What is the distance between the high point of a transverse wave or the compresion point of a compresion wave?
wavelength
Why are there two batteries on the diesel ford F250?
because diesel are very high compresion, it takes alot more cranking power for a diesel that a gas motor
Whats the compresion ratio of a 300zx?
Not sure about first generation, but for second generation the twin turbo models have an 8.5:1 ratio and the NA motor has 10.5:1 compression. Which is why you have to be very careful when trying to turbocharge an NA motor.
Why is diesel is not used in petrol engines?
Because diesel is ignited of heat and high high compresion not a spark on lower compresion petrol engine. If you use diesel in a petrol you will end up with your engine knocking and pre-detonation followed by your engine blowing up pretty bad.
Where is the heater resistor located on a 2007 dodge nitro?
The heater resistor on a 2007 Dodge Nitro is typically located under the dashboard on the passenger side, near the blower motor. To access it, you may need to remove the lower dashboard panel. Once exposed, the resistor is usually mounted on the HVAC housing and can be identified by its electrical connector and multiple terminals.
Can you shrink compresion shorts?
these nuts
What year is a Johnson Nitro High Performance boat motor with VIN?
Need additional information...Thanks.
Value of Lefever Nitro special shotgun?
The average cost of a Lefever Nitro Special shotgun at auction is $650. This amount may be higher or lower depending on the condition of the gun.
Why wont my polaris 250 trailblazer which has spark i have compression i have gas to the motor it still won 't start any ideas?
When you find out let me know,, i have a 2001 250 trailblazer doing the samething..someone told me it might be compresion also..do you know what the compresion should be ?? Richard Fisher rfisher1169@gmail.com if i find out anything i will let you know as well
