5ml of the 1000 ppm solution in 95ml distilled water gives a 500ppm solution
10 g is 10,000 mg and in 1 liter that would be 10,000 ppm. You need to have a volume in order to express the mass as ppm. In other words, 10 g NaCl cannot be expressed as parts per million unless you have the volume that it is in. If it's in a liter, then you will have 10,000 ppm.
100ppm means, you need 100mg in 1oooml. Thus, for 100ml solution, you will need 10mg of methanol to make 100ppm solution.
20 ppm means 20 gm of bleaching powder be added in water
3200ppm would have no affect on the freeze point of water, so your answer would be 32 degrees.
You prepare a primary solution then dilute portion of your solution down to the required concentration. For example, you want a 10 ppm salt solution (10 mg/L), you dilute 1 g of salt in 1 L of water you get 1000 ppm salt solution. You take 10 ml of your salt solution (0.01 g salt in 10 g) and add in additional 980 ml of water then you get a 10 ppm weight solution.
7
Dear friends, PPM means Part Per Millions, So It means if you takes 1 gm of Solid Chloride Ions and Dissolve it in D. water. The Current Stock solution is having 1000 PPM of Chloride Ions. NOW if you want lesser PPM solution from this stock Solution, follows below rule- Required PPM Solution (A) ---------------------------------- X Required Volume of A PPM solution === Nos. of mL Stock Solution PPM (1000) to be taken from this stock solution and add in required Volume. Dr.P.Khemariya Research Scientist R&D dr.p.khemariya@gmail.com
5ml of the 1000 ppm solution in 95ml distilled water gives a 500ppm solution
Make a 1 to 100 dilution of the original 1000 ppm solution. That is take 1 ml and dilute to 100 ml, or take 10 ml and dilute to 1000 ml. This will give you a 10 ppm solution.
10 g is 10,000 mg and in 1 liter that would be 10,000 ppm. You need to have a volume in order to express the mass as ppm. In other words, 10 g NaCl cannot be expressed as parts per million unless you have the volume that it is in. If it's in a liter, then you will have 10,000 ppm.
No
how to prepare 1000 ppm solution of nickel carbonate
That completely depends on how much solution you need to end up with.If the solution is to be 1,000 ppm by weight (or mass), then you add 1 gramof KCl to each liter of water.
Check your stabilizer level (or conditioner) it should be 40-60 PPM. Next check your salt level, should be 3000-3600 PPM. If their both in line; make sure your chlorinating cell is clean. If there is algae in your pool you must shock it with regular chlorine. See instructions on label.
>30ppm in 100g =? mcg in 1g
100ppm means, you need 100mg in 1oooml. Thus, for 100ml solution, you will need 10mg of methanol to make 100ppm solution.