0
Although I have never attempted to do this, it would seem possible to drill out the Baseball with a power drill and then to use a quick set epoxy cement to anchor the baseball onto the gear shift arm. I'd suggest you first try to measure the diameter of the gear shift arm and then select a drill bit just a size smaller. Then drill at least 3/4 the way through the baseball to ensure a good mount upon the gear shift arm. Before injecting the epoxy into the core you have drilled out you would be best advised to be certain the ball will screw onto the arm tightly. Quick set epoxy, available at most hardware stores, should set up in about five minutes.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Will not shift from first gear?
Make sure you push in the clutch.
How do you change the shifter knob on a automatic 1994 Pontiac Firebird?
I have a 94 Firebird and on the bottom of the shifter knob there is a "U" shaped clip. You will have to shift into L1 to see it since it is on the front of the knob. Once you pull out the clip, it slides off and you can replace it with whatever kind you wnat but make sure the "push to shift" function is on the new knob.
Chrysler 300 2006 gear shift is stuck in park how to disengage?
There is a plastic piece inside the gear shift console that breaks and makes it impossible to move out of park without special effort. Do not try to force the gear shift or you will just make things worse.
Why won't an automatic Chevy Tahoe shift into gear?
Zubie make her dance!
Why and how do you fix 1996 grand pre second gear shift light?
To fix a gear shift light, the first thing that needs to be done is checking the fuse box to make sure that all fuses are intact. The reason you would fix a gear shift light is, so you know what gear you are in. Driving in the wrong gear can cause transmission problems.
How do you remove the automatic shift knob in mk4 jetta?
To remove a automatic shift knob in mk4 jetta or gulf 1.you need to make sure the shifter is all the way down in 2nd gear. 2.After the shifter is down you need to pull the button off. You may have to pull hard but dont worry you wont break it. (if it were an egg on its side, grab what would be the top and bottom of the egg if that helps) 3.once the button is off, there is an internal piece that will be exposed. you must pull that piece out also. use pliers if you cant grip it with our fingers. 4.now with a knife or a firm grip pull the chrome piece at the base of the shift knob down. 5.after that the shift knob should slide right up.
Where is a synchronizer located at on a Geo Metro?
In a manual transmission between the gears. If one fails it will make it very difficult or impossible to shift in to the lower gear, i.e. if the 2nd gear synchronizer goes out you cant shift from 3rd to 2nd gear
Why would a turbo350 make a sound like it pop's out of gear shifting from first to second gear and then not shift at all?
maybe you broke something!
Where can a replacement shift knob be purchased?
If one is interested in purchasing a replacement shift knob it is recommended to check out popular stores like Auto Zone or Rock Auto. Also, Amazon may offer these as well. Make sure to check out the local listings in one's area.
What is make a transmission make whining sound and shift hard into the higher gear but not when downshifting an automatic?
fluid braking down
What would make your key get stuck in the ignition of a Pontiac Aztec?
i have that problem to it has something to do with the gear shift censor
Why when you shift to drive it seems to just rev up but when you shift to low 1 gear it shifts and catch speed?
Sounds like your hi gear may have gone out. Take it to a tranmission shop they can run a check for you to make sure.
