0
take 10 liter of distlk water and add 100 gms ethelyene glycol in it mix it throughly and it is ready
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is reservoir?
The reservoir is usually considered to be the tank which holds coolant. It feeds the coolant into the radiator when needed, and receives coolant from the radiator as is necessary. This is where you check and maintain the coolant level. Make sure the cap is on quite tight.
Is the water reservior just for water or for coolant for the radiator?
Radiator coolant.
Where does the coolant go?
Coolant goes in the radiator or you can also fill the radiator resevoir.
Why does your Chrysler PT Cruiser over heat when the AC is on?
Low coolant, radiator restriction.Low coolant, radiator restriction.
HOW TO DRAIN and refill COOLANT from a system which doesn't have radiator cap Would the coolant reach the radiator is we refill the coolant through the coolant header tank?
In systems that do not have a radiator cap, the coolant is drained by the radiator drain plug. It is filled by adding coolant to the system through the overflow bottle.
Can you put coolant straight in to the radiator?
Yes you can put coolant right into the radiator. Just make sure it is a 50/50 mix of the correct anti-freeze and distilled water.
Why is 91 Honda accord ex coolant radiator is cracked?
If the radiator is cracked then the vehicle has ran dry on coolant. This would cause the radiator to crack if there wasn't any coolant.
Where do you add coolant to your c240?
You add coolant to a C240 at the radiator overflow tank. This allows the radiator to suck in coolant as needed when hot.
How can you make coolant?
One gallon and antifreeze and one gallon of water are needed to make coolant. They are then mixed together in a large bucket and then pour into your vehicles radiator.
How do you change coolant on n16?
Do this when the engine is cold only. First, remove the radiator cap. Then, locate the lower radiator hose. Unfasten this from the radiator. The old coolant will come out. Wait until the coolant has all come out. Then fasten the radiator hose again, make sure it is tight. Pour the new coolant into the radiator. Then, start the engine and let it idle. Pour more coolant into the radiator until it is almost full. Leave a space of 1 cm or so as the hot water will expand in the radiator and needs more space than cold water. Then, replace the radiator cap. Make sure the radiator hoses are not cracked or leaking. Check the coolant every week on older cars, at the same time as you check the engine oil level. Be careful with this, as the pistons will seize in the cylinders if the cooling system runs dry or even partially dry.
How does one flush a radiator?
One flushes a radiator by draining the radiator, rincing the radiator, and then by adding a new coolant. One should remember that the drained coolant is toxic.
How much coolant for Suzuki scrum radiator?
Coolant for Suzuki scrum radiator costs approximately $107.50.
