answersLogoWhite

0


Best Answer

reverse then hit the brakes hard do this a few time and the self adjusters should adjust for you

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you make the brake pedal hard after changing your rear brake pads on your vauxhall vectra?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why is my brake pedal clicking on your vauxhall vectra?

There is an electronic relay switch which turns on the rear brake lights-It's located behind the brake pedal- It clicks when you push the pedal down, making contact.


Brake lights will not turn of in vectra?

the switch on brake pedal is faulty and needs replacing


Why will the gears not engage and the cluch pedal is soft on a vauxhall vectra 2.0 16v?

probably the clutch cylinder is gone :(


Clutch pedal wont stay down to change gear on vauxhall vectra 1991.1.8?

You have to keep it down with your foot!


Vauxhall astra stoplights not working?

If none of the brake lights are working i would suspect the brake switch at the brake pedal.


Vauxhall Astra van brake lights are not working and its not the fuses what could be the problem?

Check the bulbs. If these are OK it could be the switch on the brake pedal arm.


Why are the brake lights on 1999 Monte Carlo not working after changing bulbs and Fuses?

Brake light switch on the brake pedal is defective


How do you reset the maintenance inspection light on 2003 vauxhall vectra?

Hold the break pedal down and the milometer trip button turn on the ignition whilst holding these in the service light will flash then resets


Where is the switch under the brake pedal you cant find it?

It is above the brake pedal not under it. Follow the brake pedal bracket all the way up and you will see the brake pedal switch.


How do you fit a vauxhall vectra clutch MASTER cylinder AND how do you determine if its knackered?

Remove the clevis pin from the pedal the remove the master cyl from the bulkhead A quick way to test the cylinder is clamp the flexible hose that leads to the slave cylinder when the hose is clamped, the clutch pedal should be solid.


Where is the brake light switch on a 93 Dakota?

Just above the brake pedal, on the mounting bracket that the pedal pivots on.Just above the brake pedal, on the mounting bracket that the pedal pivots on.


Where is the Emergency brake pedal on a 1966 Thunderbird?

to the left of the brake pedal