You need to buy a cold air intake for your car. It replaces the stock air intake.(the box your air filter is in!)
they didnt make a sephia in 2005
add Turbo, Cool air intake, supercharger,etc...
Purchase an AEM cool air intake
In a 1994 Kia Sephia, the thermostat is typically located in the engine compartment, near the engine block. To access it, you usually need to remove the upper radiator hose, as the thermostat is housed in the thermostat housing at the end of that hose. Make sure to allow the engine to cool before attempting to locate or replace the thermostat.
Go to this website: http://www.kiatechinfo.com/index.asp It's free. It has all the engine stuff there. You just need to give them an email address and make up a password.
In a 1997 Honda Passport, the thermostat is located on the engine block, near the intake manifold. It is typically found in the thermostat housing, which is connected to the upper radiator hose. To access it, you'll need to remove the hose and the housing cover. Make sure to allow the engine to cool before attempting to locate or replace the thermostat.
The air intake sensor on a 2003 Dodge Durango is located inside the cool air intake at the front of the engine compartment. It allows the engine to make adjustments based on the temperature of incoming air.
it may be a dirty oil filter try changing it and see if that works if it does let me know i have the sane car except it is a 1997 bye
if it sounds like a high pitched whining then it may just be your cool air intake
On a 1997 BMW 318i, the thermostat is located in the engine compartment, specifically on the engine block near the water pump. To access it, you typically need to remove the upper radiator hose and sometimes the air intake duct. The thermostat is housed in a metal housing that is bolted to the engine. Make sure to allow the engine to cool down before attempting to service the thermostat.
you can put a turbo kit in it then an air filter and i liked it when i pput in an iceman air intake.
On a 1997 Lincoln Mark VIII, the intake manifold runner control (IMRC) for bank 1 is located on the driver's side of the engine. It is part of the intake manifold assembly and is responsible for managing airflow to the engine's cylinders. You can access it by removing the intake manifold cover and looking for the IMRC linkage and actuator on the left side of the engine. Make sure to disconnect the battery before performing any work in that area.