Want this question answered?
locking mechanism is buggered.. have to unlock manually and replace
You must pull off the rear interior panel and manually release the mechanism. It can be difficult and cumbersome. Be certain to not break the plastic!
four hundred
release gas pressure, get to the pump mechanism under the back seat, replace the pump in the mechanism
wiggles bandaids
Not removable- replace entire hinge assembly
replace the pump replace the pump
Under the drivers seat area, under the truck on the frame rail, you will see the E-brake cable junction. Gently pry this apart and the brake will release. This will allow you to drive the vehicle until you can replace the release lever assembly. Remenber, your brake will not function until you replace the release lever. How about looking at the pedal mechanism just above the pedal and pulling on the release mechanism at the top of the toothed ratchet area where the cable would be if there was still a release cable.
?need to replace the cable to a 1979 buick regal, the emergency release mechanism wire broke. Don't know how to release the brake?
my hood latch did the same thing, and i found the only way to make it catch is by manually pushing the hood release button BACK IN before closing the hood and then it seems to work fine If you have to manually push the release back in to operate the mechanism, you have one of two problems. The spring on the hood latch is broken or the hood latch or release cable is corroded and sticky. Locate the hood latch near the radiator and spray it liberally with a penetrating lubricant, visually check to see if the return spring is broken. If the spring is good and the lubricant doesn't fix the problem you will need to replace the cable, which looks much like the brake cables on a bicycle.
You have to find the alternator then look at where it is connected to the motor there will be a slide mechanism that you will have to loosen which will release the slack on the belt so you can get it off.
1 higher pair can replace 2 lower pair.