answersLogoWhite

0

Read the manual

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What are the Causes of phase angle error and ratio error at Current Transformers?

RATIO ERROR The secondary current is less than the expected value. The secondary is less in magnitude. This diffence is known as ratio error. PHASE ERROR The angle between the expected and actual secondary current is known as phase error.


How differential protection work in a transformer?

Power flowing into a transformer must match the power flowing out (minus losses which are minimal). If this is not the case, there's something wrong. Differential protection monitors current only; Current flowing into one side of the transformer will be equal to current flowing out the other side scaled by the turns ratio of the transformer. Since the turns ratio is equivalent to the voltage ratio, this is easily set.


How do i convert from 380 volts to 220 volts?

If these are the exact voltages that you need you will need an auto transformer to obtain these voltages. If these voltages are nominal voltages and are of a three phase four wire configuration, the 220 voltage can be obtained from the three phase legs to the neutral (ground) connection. The equation to use is 400/1.73 = 231 volts.


How can you tell if a transformer is a set up or set down?

The same transformer can be both. It must be operated at the correct voltage on both windings.


Why is a set up transformer needed in a stereo or tv set?

A stereo or tv set needs a step-up transformer because a step-up transformer increases the voltage of an appliance and a stereo or and a tv set needs a high voltage.-------Semper Fidelis(ADC)----------


Is a transformer load inductive or capacitive?

A transformer is fundamentally a set of coils; therefore, a transformer is an inductive load. However, by "transformer load", you seem to mean "the load that is connected to a transformer". Whether that load is inductive or capacitive depends mostly on what is hooked up to the transformer.


What is the purpose of a test for a doorbell transformer and how can it be conducted effectively?

The purpose of testing a doorbell transformer is to ensure that it is functioning properly and providing the correct voltage for the doorbell system to work. This can be done effectively by using a multimeter to measure the voltage output of the transformer. Simply set the multimeter to the AC voltage setting, then touch the probes to the terminals of the transformer to get a reading. A properly functioning transformer should provide a voltage within the specified range for the doorbell system to operate correctly.


What is the minimum load require to put transformer?

A transformer requires a 75-kVA minimum load in order to be set.


Can you use any ho transformer for a ho train set?

As long as the transformer is capable of 12 Volts DC output, you can use any transformer with HO scale equipment.


What is defrential protection relay?

I am going to assume that you are asking about a differential relay. It is basically just that- it compare two different sources and will trip at a set value value of the difference. These can be directional as well. A couple of examples are transformer protective relays and bus differential. A transformer relay will measure the amount of current coming into the transformer and the amount of current going out. If there is a disparity due to an internal fault the relay will trip the supply source and deenergize the transformer. Same for the Bus differential.


What are the powers of the Train Transformer?

A model train set will need a transformer to power it. On most modern train sets the power of the transformer is usually between 8 and 18 volts and will differ by manufacturer.


What is the different between et up and set down transformer?

the difference between a step up transformer and a step down transformer is that, in a tsep up transformer, the voltage secondary is greater than the primary side but in a step down transformer, the voltage secondary is lesser than the primary side