0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you wire 4 dual 4 ohm coils subs to one ohm mono?
If you wire all 4 coils parallel, you get 1 ohm (mono).
What is a 0 ohm link?
A zero ohm link is a piece of wire, a jumper.
How do you wire two 4 ohm speakers into 2 a two ohm load?
Parallel
How do you wire two 8 ohm speakers and keep a 8 ohm load?
in parallel No. Two 8 ohm 'speakers in parallel present a 4 ohm load.
The resistance of earth wire in ohm is?
5 ohms or less.
What size amp do i need for two 10 inch kicker comp's?
You could go with a 600 watt 2 ch amp or a 300 watt mono block amp, depends on what OHM the subs are, if they are 8 ohm you could wire them down to 4 ohm or if they 4 ohm u could wire them to 2 ohm, i have a 600.1 Boss amp and subs are wired together at 2 ohm and they BANG.
What is the difference between resistance and the resistivity?
Resistance is the value of a given wire in ohm but resistivity is value of the material with which that wire is made in ohm meter. R = rho * L / A Here rho is resistivity and R is resistance. L is the length of the wire and A is area of cross section
Who was Mr Ohm of Ohm's Law?
The law was named after the German physicist Georg Ohm who, in 1827, described measurements of applied voltage and current through simple electrical circuits containing various lengths of wire.
Can you wire 2 ohm amp at 175 watts to a 4 ohm subwoofer?
Theoretically yes. At 4ohms though, it will only be putting out about 88 Watts.
If an amp runs 1000 w rms at 1ohm how do you wire a dual 4 ohm speaker to run at 1 ohm?
the impedance of a speaker is a characteristic that is has. A 4 ohm speaker will always have a 4 ohm impedance and it cannot be changed. If 2 speakers of 4 ohm impedance are wired in parallel, then the total impedance will be 2 ohms. Similarly, if you wire 4 speakers together, the total impedance will be 1 ohm. Wiring a 2 ohm speaker to an amplifier rated to drive a 1 ohm load should work without any problems but expect the total power output to be somewhat lower than with a 1 ohm load.
I HAVE A crunch 1000.1 AMP THAT im trying to push 1 punch p3 15 subwoofer how do i wire it?
If youre running a single woofer get the dual 2 ohm woofer. Wire them parallel, which will bring it down to 1 ohm when you put it on the amp. 1 ohm will pull the most power from the amp
How do you wire up a dual 4 ohm sub to 2 ohms?
i dont now
