Want this question answered?
If the 71 is a standard then yes it will fit.
If you open the door wide you will see that it only has a pin sitting in the hinge , just knock it and it should come out with ease.
Yes.
Open hood, locate slide lock, push tab and rotate upward. Pull the whole assembly out to the front.
open the hood and take the screw out that holds the strap which wraps around the glove box. Remove the glove box and set aside in the hood area being careful not to break the plastic hood cable tube. You will be able to see where the glove box latch spring tab is keeping the door shut. Squeeze the latch and push to open the door. Replace the lock assembly by removing the large nut on back of the glove box door and reinstall new one. align the door properly with the 4 phillips screws on the door and trial fit. Once it works properly reinstall the glove box and strap.
On a Classic Bug you don't need one. There's a spring in the middle of the hood (the one over the engine) that holds it up for you, and the trunk lid has hinges with springs in them.
You don't because there isn't one. Cam drive on a 1974 Bug is done through a big gear riveted to the end of the cam, that engages a gear on the crank.
You have to slip in a slimJim and grab the latch hook and pull straight down while putting downward pressure on the hood. If you don't know what a slimJim is look it up. I would also encourage you to lalso ook up the hood latch part for your car so that you can see how the latch hook catches the lower latch cup.
No, the hood will not fit. 1965 is pre-Super Beetle; 1973 is post Super Beetle. The 65 hood is going to be much more narrow and arched then a Super Beetle hood or anything past their early transitions to the Super beetle which started to transpire in June of 1971
how do i get into a trunk o f a vw bug 1972
It needs an IRS Bug transmission. Any Bug from 1969 until end of production will have the right transmission in it.
On the 98 model, the release is on the side wall by the brake. When it is pulled another release comes out from under the hood. Pull that one towards you and the hood is relased.