Swimming Pools
Pool Building and Repair
Pool Care and Cleaning

How do you open an inground plaster pool?

Top Answer
User Avatar
Wiki User
2015-07-15 21:24:23
2015-07-15 21:24:23

For my pool, I do the following:

Pool Opening:

Add water to above skimmer

Open heater and connect heating port inside

Reattach chlorinator and lines

Connect heater at grey lines

Remove skimmer plug

Remove rubber plugs from jets

Reattach black plugs to pump (2) and to filter (1)

Reinstall filter cartridge

Take a water sample to a pool store for a free water analysis

Related Questions

User Avatar

Why would you drain your pool just becasue the water is hot? Never drain your inground pool unless you have first cut holes in the bottom of the pool to keep it from floating. If the water table in your area is high enough, your inground pool could "float" out of the ground, effectively ruining your pool.

User Avatar

Outdoor pool Inground pools.

User Avatar

Gunite is covered with plaster. It is sprayed on concrete sorta. They mix it in the hoses and it is blown on. You can go to youtube and see them gunite a pool. I am only aware of plaster, vinyl or painted pool surfaces. The vinyl is just like thin rubber.

User Avatar

Any pool supply store should be able to help you find coping and plaster. While they may not carry it in the store, they will most likely be able to direct you to a distributor, or set up a delivery for you.

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.