you have to get a special tool to do it because on the rear breaks since it is all disk break the rear calipers twist in so u have to have a tool that u can rent from any advanced auto or auto zone and u use it to twist them in ......... i just recently had to do this on mine ...............hope it helped =]
under back seat
Depends on the noise, my tiburon was making a noise in the back, but it was just the cover for the trunk nothing big. Whats the sound, sound like??
its in the panel on the left of the back seat behind the drivers side.
located on the back side of the engine as you look at it and is accessable the easiest fron underneath
On the 2001 it's in the gas tank, it can be accessed by removeing the back seat threr is a access hole
No, the lug size, spacing and back spacing will be different.
I have 2 12" subs in my 2005 tiburon w/ a big ported sub box and it fits just fine. In fact there is extra room back there for a few smaller items.
in the internal fuse box on the back unplug the cables that go into the board. REMEMBER TO MARK WHAT GOES WHERE.
the lights come on to let you know that your car is locked
Drop the steering wheel, at the back of the ignition there are wires with a screw in the middle edge. Remove the screw, unplug the connector and it comes right out.
To change the back speakers in a 2005 Hyundai Tiburon, start by removing the rear side panels. This typically involves unscrewing any visible screws and gently prying off the panel to access the speakers. Once exposed, disconnect the wiring harness from the old speakers, unscrew them from their mounting, and replace them with the new speakers. Finally, reattach the wiring, secure the new speakers, and reinstall the side panels.
the starter is located on the intake part of the block in the center of the engine compartment. from the driver side look for the shifter cables on top of the trans axle and it is straight back from there.