Take the inside panel off and pull up on the lower cable and down on the upper cable.
how do you open the hood on a 1992 buick regal if the cable is broke
cable broke release latch for the hood can't open it
How much cable came out when broke? Cut the plastic cable back to the point where you can see the steel cable core and pull with vice grips to open. You can pull the cable around to handle easier.If it broke under the hood try to find the cable and do the same.
Open-top containers are used for all types of general cargo (dry cargo). Their principal uses are as follows: packing and unpacking from above or through the doors by crane or crabtall cargo
grab the broken end of the cable with vice grips and pull it
Euro 4 Van Transit front doors open on fob but do not open side door or back door is it the fuse
Yes, the Ford Expedition is equipped with rear barn doors, which provide easy access to the cargo area. These doors open outward, allowing for convenient loading and unloading of items. This design is especially useful for larger items and enhances versatility for various cargo needs.
Ecklers has the replacement cable and "Installation instructions" which show how to get the hood open so you can relace the cable. Tried to attach the diagram, but no attachment tool here.
Find the place where the cable runs from the opener to the door. check if its broke somewhere. You can also pull on the cable at the door itself and see if it will open.
If the cable broke at the pull under the dash, and it is still sticking out of the casing, behind the pull, you should be able to grab the end of the cable with a pair of plyers and give it a yank to pull the cable and open the hood. If it broke somewhere between the pull, inside the car, and the latch, under the hood, best bet would be if you can see under the front of the car and reach up, you can release it that way, by pulling on the cable.
Reach up under the center with a long screwdriver and open it.
if your latch just broke, use a vice grip. if the cable itself has snapped, it gets tricker. my 2nd cutlass's cable snapped. i had to lift and jerk the hood manually until it came loose.