0
Disconnect power and video cables from monitor. Place screen on table, back side up. Remove 4 Phillips head screws that hold the stand to the back of the monitor case, and remove stand (base). Flip monitor case up, screen facing you and bottom up. On the bottom edge by the two corners, approximately 1-1/2 inches from the sides, there is a small rectangular slot between the screen bezel and the main case. Start on the right side (not side with power switch) and insert a flat blade screwdriver in the slot and give it a twist clockwise, prying the bezel corner off the case.
Observe the plastic clip on the bezel with three holes in it to the right of the slot as you pry open off bezel. There are four more clips like that one on the bottom edge of the bezel. Insert a sharply pointed knife (a steak knife or similar) between the bezel's surface and the case's inner surface, and slide it to the left, pushing the point toward the other clips. They will pop open as you go. Next, do the same on each side, and finally on the top edge. This will completely loosen the bezel from the case.
There is a small printed circuit board with the power and other control switches and it's cable to the monitor's chassis, mounted on the bezel by three small Phillips head screws. Unscrew them and remove the board from the bezel. Now you can lift the entire chassis out of the rear case.
To access the inverter/power supply printed circuit board and others, remove the small screw in the cover shield and slide it in the opposite direction of the arrow and remove the cover. Do the same for the other cover (no screw there), to gain access to the plugs underneath. Carefully unplug the 4 CCFL cables, and make note of their positions and color orientation. Unplug the large LCD panel cable by squeezing the sides of the plug and pulling on the plug (not the cables) to free it. After removing the two screws on each side of the chassis, you can remove the LCD panel from the chassis cover, exposing the inverter/power supply and VGA input boards. Place the panel in a safe place to prevent damage. You are now ready to make repairs!
Wiki User
∙ 12y ago
Wiki User
∙ 14y agowill you plz let me knw wht is the model of your computer so that i can tell u hw to open the case.
Add your answer:
Earn +20 pts
Is the Dell Dimension 8400 wireless capable?
Yes, it's. You have to purchase either a PCI wireless card (you will have to open the computer case to install it) or USB wireless adapter (which is easier to install, just put it one of usb ports).
How do you open a NEC computer case?
Throw it out the window
How do I open disc tray dell desktop computer?
Depends on the model. Some you push on the tray cover and with others there is a button next to it.
How can you connect a hard drive from a broken Dell computer to a working Gateway computer?
Would I need an external hard drive case? I opened up the Gateway and there are no cords that would be able to connect to the hard drive from the Dell, unlike someone had told me. Though I understand because they are two different computers. Answer: Shut down the computer. and then open cabinet and remove hard drive power cable and data cable. and screw. and then install new hard drive.
Which of the following is an output voltage of a computers power supply?
This can very greatly from computer to computer. You will have to open the case of your computer to tell.
When did Dell first open?
Dell was founded on 4th November 1984.
How do you remove the hard drive on a Dell Dimension 2350?
To remove the hard drive on a Dell Dimension 2350 desktop computer, one has to open up the system unit. The hard disk can then be unscrewed from the drive bay.
How do you unlock and open your dell laptop?
it back to the store you purchased it from and they will fix it and if they don't sell it on-line get the money that you got from selling your computer and buy a new one or do something else with the money
Is computer support from Dell available 24/7?
Yes, Dell offers support on a 24/7 basis from their support center in India. You can get the support you need via telephone or open a chat session. If you are having issues with your computer the chat might be preferred as they can remotely look at your system (with your permission of course).
How do get inside the computer to get to the hard drive?
it depends on what kind of computer you have, butreally you just would open the computer case, then unscrew the hardrive from the bracket and there you go.
How do I tell if my computer has a free PCI slot?
You will have to open your computer and look inside your case. In 95% of motherboards, PCI slots will be white.
What has occurred if you see the message Chassis Intruded! System has halted. the next time you start your computer?
This message means someone tried to start the computer with the case open, AND that the BIOS is set to halt if the chassis intrustion switch indicates that the case is open.
