answersLogoWhite

0


Best Answer

Pull the hood release under the dash at the left side.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you open the hood of a 1998 Mercury Villager?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

The hood release of your 1998 mercury mountaineer will not open up?

my 1998 mountaineer hood release will not work. Is there another way to open it?


What is the spark plug gap on a 1995 Mercury Villager?

Open the hood and look under the hood or on the radiator assembly. There you will find a placard with this info. It is also listed in your owner's manual. the gap for a 95 villager is .032


How do you open hatchback or trunk on Mercury Villager?

Pull the latch.


Where is the starter located on a 1995 Mercury Villager minivan?

The starter is located directly underneath the brake fluid reservoir (which is located on the right front corner as you open the hood)...good luck


How do you open back hatch of a 1993 Mercury Villager?

Follow the instructions on Youtube.


How do you open your back window on your 1999 mercury villager?

Turn the key to the right.


What size tires go on a 1997 mercury villager?

On a 1997 Mercury Villager open the drivers door and on the latch pillar you will see an information sticker that shows the original size tires on the vehicle from the factory


How do you drain radiator for a 1996 mercury villager?

Open the drain plug on the passenger side of the radiator.


How do you open fuel door on 1996 Mercury Villager?

The button is right below the seat ontrols


Mercury villager 1999 Sliding door will not stay open?

If the sliding door on the 1999 Mercury Villager will not stay open, check for something that is not allowing the latching mechanism to lock into place. Make sure that the door is all the way back so that it can lock in.


How do I open hood with dead battery to my 1998 MB S420?

Open the door with your key and pull the hood release.


Where is the 02sensor bank1 sensor 1 loctaed on 96 Mercury Villager?

Bank 1 is the left or front exhaust manifold. Open the hood and look straight down. It should be screwed into the manifold before it bends under the engine.