Have someone pull the hood release lever at the same time open the hood using a flat tip screwdriver
I have dealt with this problem before at our bodyshop. Basically, a spring inside the latch has broke, and now there is no way to release the latch, even by manually pulling on the release lever at the latch. Prepare to replace the latch, as it is not repairable. Be prepared to be working inside the car. To make it easier to work, unbolt the seat, and remove from the car. Remove the door panel, and also the door handle. You will have to chisel at the plastic part of the latch, and break it off bit by bit. Eventually you will be able to release the latch. good luck
Ford usually has sensors inside the door on top of latch
crowbar dude...
The hood on a Volvo S60 can be opened when the latch is not working by sticking a stiff piece of wire into the grill and pulling on the release latch. The latch can then be repaired or replaced.
climb under there with a flashlight and a screwdriver and release the latch climb under there with a flashlight and a screwdriver and release the latch
The lift gate on a 2003 Dodge Durango can be opened from the inside if the latch is not working. There is a latch on the floor close to the door that can be tripped with the use of a screwdriver to open the gate. The cable for the gate might need to be repaired after this.
You have to remove the inside door panel to get access to the door handle nuts.
The latch itself is held on with bolts, easy enough to change. The release cable has to be fed down the inside of the rocker panel and into the trunk.
Why did my Mercedes Benz s350 key is no working again
The cable between the latch and the handle may be broken or needs adjustement to shorten the cable so that the latch will fully release.
Inside the glove box, left hand side.
It is part of the latch, inside the door.It is part of the latch, inside the door.