Want this question answered?
Open the hood. Above the head lights under the hood on the flat surface above the head lights are two metal rods. They are exposed and are about an inch long. They are held in place with plactic tabs. These two metal rod hold the head light assemble in place. Pull these two rods up and out of the head light assemble. The entire head light assemble will come loose and you have full access to the light bulb socket on the back of the light bulb assemble. Very clever way of doing thing, just hard to figure out.
Open trunk, there should be a few screws that hold tail light assembly to car. Remove screws and pull tail light assemble straight back.
Look in the trunk, there is a cover over the light assembly - open and you will have access to change the light.
Just open your rear door and you will see screws on each side close to the brake lights . just take those out and the light will slide out and then just twist the plug to open and replace the bulb
How do you open tool compartment on your 2004 Suzuki GSX r 600?
I have the ZX5 2003 and when I did it I had to open up the trunk and go through the inside.
To change the turn signal light in the 2003 Subaru Baja you need to have a tool box with the necessary tools. Open the screws to access the turn signal light and replace it.
No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.No. It needs to be saved in 2003 format from 2010 to enable 2003 to open it.
open the trunk. the assemble is lossened from in there.
Open tailgate. You will find 2 screws that take a star tool. Take them out. Pull the tail light assemble out. Unplug the wiring harress. Remove the 2 screws that hold what looks like a curciut board. Separate the board from the lens. pull bad bulb out and replace with good one. reverse procedure to assemble.
hello i have had the same problem it locks and everything if your boot light comes on its not your boot if it doesnt (when bboot open) its our boot seor
Open the engine compartment hood. Locate the light bulb connector on the back of the headlight. Take hold of the connector, push in and turn at the same time. The light bulb will come out.