answersLogoWhite

0


Best Answer

Check the hood and radiator supports for a vacuum lines diagram.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you place the vacuum lines on a 1997 Chrysler Sebring 2.5 LXi?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where can you find the engine diagram for a 2.7 liter Chrysler Sebring?

The best place to find an engine diagram for a Chrysler Sebring would be in the owner's manual. If you do not have your, contact Chrysler or check your library.


Do the back seats lay down in a 2005 Chrysler sebring convertible?

No. The seats are bolted solid in place.


How do you replace windshield washer pump Chrysler sebring convertible?

The windshield washer pump on a Chrysler Sebring convertible is replaced by disconnecting the wiring harness and unbolting the pump. It can then be lifted from its mounting bracket and a new pump put into place.


How do you take the skid plate off to change oil on a 2007 Chrysler Sebring?

You remove the screws that hold it in place.


Where can you get replacement windshield washer nozzles for a 2001 chrysler sebring?

The dealer would be the first place I would check.


Chrysler sebring water pump?

The best place to look for aftermarket car parts is the World Wide Web. I found quite a few retailers selling Chrysler Sebring water pump online. You should be able to find some really good deals since this is an extremely competitive market. In fact, I found a wide range of water pumps for Chrysler Sebring on 1aauto.com. If you place an order before 3pm Eastern Time, they'll ship it to you the same day!


Will the rear seat on a 1996 Chrysler sebring convertible lay down?

No, the seat back is bolted in place.No, the seat back is bolted in place.


Where is the battery on a 2005 Chrysler sebring convertible?

I have a 2001 sebring and they tend to place the battery in the front driver fender area. You have to remove the front driver tire, then remove (pry or unscrew) the bolts that hold the fender shield in place. It's most likely there in the fender/ bumper area.


Where can you get a pcm for a 1996 Chrysler sebring?

I found a place where you can buy PCM' for 96-06 Chrysler Sebring, Dodge Stratus & Cirrus with a lifetime warranty, programmed & updated for your VIN & mileage. I found a PCM there for my 1997 Chrysler Sebring Convertible JS which has California emissions...so a hard part to find on the East coast. I will be buying it in about 2 weeks, so I'll let you know how it goes! http://www.allcomputerresources.com/ 1-866-699-5230 ALL Computer Resources, Inc. $199 FREE Shipping


Is there a place on the Internet where you can find out how and where to hook up all the vacuum lines on the engine correctly?

if you go to autozone.com they havve repair manuals with the vacuum lines you just pick your car and engine and check for the emmissons area


How much does a tune up cost for a V6 97 Chrysler Sebring?

about 350.00 just for the fact some of the wires are in a bad place. to wear they have to take apart some of the engine to get to it.


Where are the fuses on a 2001 Chrysler sebring convertible?

I have a 2002 and the fuses are located just inside the door on the driver side of the dash. Not sure about the 01, but it may be in the same place. Good luck.