Many vehicles have a programming method associated with the door locking and driving lights. To find out more about it, check in the owners manual.
P0340 is a failure in the cam shaft sensor circuit. That can prevent the engine from running.P0340 is a failure in the cam shaft sensor circuit. That can prevent the engine from running.
You could remove the power door lock fuse or relay.
No non-use of the seatbelt will not prevent the engine from running.
After the engine has cooled to a certain temp, it should shut off. If it is running constantly, this is an indication the engine is overheating.
to dissipate the residual heat in the radiator it will shut off automatically
It should be locked when ever someone has to do repairs or service in the center area to keep the person from being crushed.
Keep engine running idle speed
to do this, you need to enter the code, then whilst the engine is running, you need to remove the fuse marked BIC/Ilum, turn the engine off and on and then replace it, the drawback with this, is that the engine management warning light will flash when the engine is running at below 1500rpm, also the immobilizer light will flash, this can be turned off by holding in the central locking button for a few seconds.
Yes, a loose battery cable will prevent the alternator from charging the battery. The drain on the battery is not caused by the engine not running unless an accessory is left on. Most likely, the drain is caused by accessories (radio, lights, etc) while the engine is running due to the battery not receiving its charge from the alternator and then not having enough charge left to start the engine.
No. It will keep running until overheated to the point of a ruined engine.
leave the wiper stalk/control set down one stop from off when you switch off the engine, it will then work automatically when it rains and the engine is running
what is the running mate in engine