How do you program 2000 Kia keyless entry remote?

Answer 1

Locate the RKE (Remote Keyless Entry) module programming switch, it is most often located under the ashtry or under the armrest. It is installed at the point of entry in USA and the installer has leyway in placing the unit. Cut it loose from the wiring harness. The button is in the center of the round plastic holder. . The cable that the switch is on is about 6 to 8 inches long and is can be anyware, the RKE modual is a small black plastic box with a single white wire coming out of it. This is the antena wire.

Now for the programming procedure. Unplug the RKE module for 30 seconds before the programming sequence or try disconnecting the battery. The programming switch is only active for 1 min after a power cycle of the RKE module.

All Kia transmitter codes must be learned at time of programing. The system can learn up to 4 different transmitter codes.

Transmitter Programming Procedure:

- Open the driver's door. (Leave door open and make sure overhead light is on throughout procedure)

- Turn the ignition key ON (turn key all the way forward with out starting vehicle).

- Press and HOLD the programming/override button (located under dash). In approximately 20 seconds the system will start to cycle the door locks and horn will sound 3 times to indicate the system has entered the transmitter learn mode (DO NOT release the programming/override button).

- Press the ARM (Lock) button on the remote to be programmed. The system will respond by cycling the door locks and the horn will beep one time to indicate the transmitter has been learned.

- All other transmitters (up to four) also need to be programmed at this time.

- Programming is now complete. Let go of the programming/override button and turn ignition off to exit learn mode.