How do you program a 2002 Honda CR-V remote fob?

Answer 1

Programming the Transmitter

NOTES:

• The system accepts up to three transmitters. The

transmitter codes are stored in a stacking-type

memory. If a fourth transmitter code is programmed,

the code for the first transmitter is erased.

• Entering the programming mode cancels all learned

transmitter codes, so none of the previously

programmed transmitters will work. You must

reprogram all of the transmitters once you are in the

programming mode.

• You must complete each step within 4 seconds of

the previous step to keep the system from exiting the

programming mode. Program the transmitters within

10 seconds.

1. Turn the ignition switch to ON (II).

2. Press the "Lock" or "Unlock" button on one of the

transmitters. (An unprogrammed transmitter can be

used for this step.)

3. Turn the ignition switch to LOCK (0).

4. Repeat steps 1, 2, and 3 two more times using the

same transmitter used in step 2.

5. Turn the ignition switch to ON (II).

6. Press the "Lock" or "Unlock" button on the same

transmitter. Make sure the power door locks cycle

to confirm that the system is in programming mode.

7. Within 10 seconds, press the "Lock" or "Unlock"

button on each transmitter. Make sure the power

door locks cycle after you press each transmitter

button to confirm that the system accepted the

transmitter's code.

8. Turn the ignition switch to LOCK (0) to exit the

programming mode.