How do you program a BC370CRS scanner?

Answer 1

http://www.uniden.com/pdf/BC92XLTom.pdf

The manual knows all.

Straight From the Manuel:

Storing Known Frequencies

Into Channels

1. Press Hold. Then enter the channel number where you want to store a frequency, then press Func and Pgm. The channel number appears.

2. Use the number keys and to enter the frequency (including the decimal point) you want to store.

3. Press E to store the frequency into the channel. Notes:

• If you entered an invalid frequency in Step 2, Error appears and the scanner beeps three times. Enter a valid frequency.

• The scanner automatically rounds the entered number to the nearest valid frequency. For example, if you enter 151.473 (MHz), your scanner accepts it as 151.475.

• When you enter a frequency into a channel, the scanner automatically turns on the delay function and DLY appears. When delay is turned on, the scanner automatically pauses scanning

2 seconds after the end of a transmission before scanning proceeds to the next channel. To turn the function off or on, press Func + Dly.

• If you enter a frequency that has already been entered elsewhere, the scanner sounds an error tone and displays the channel that was duplicated. If you entered the frequency by mis- take, press then enter the correct frequency. To enter the frequency anyway, press E to accept.

4. To program the next channel in sequence, press E then repeat Steps 2 and 3.

Answer 2

Follow the link below to download/print the manual for your scanner. It will walk you through the programming process:

http://www.uniden.com/pdf/BC80XLTom.pdf