I
I cannot answer this question.
Step 1: Turn on your device. Press the GREEN SET button. While holding the GREEN SET button, press the device button you want to program. Release both buttons. Step 2: Press the GREEN SET button again. The red light should start flashing. Step 3: Start pressing the power button until your device turns off. Step 4: Press the device button again. Step 5: Enjoy!
Universal Indicator Green was created in 1995.
To program your keyless remote, locate the dark green program enable wire and connect to the wire enable terminal. Insert your ignition key and turn the switch to on while depressing either button on the transmitter. Disconnect the program enable wire terminal and remove the key from the ignition.
If you want to add a remote, press the "set" button on the power unit until the green light blinks, then press the button on the remote. If you want the unit to forget all old codes and accept only the new remote, hold the "set" button until the green light stays on solid, then press the remote button.
The Universal Indicator would go green which is pH 7.
To program a Comcast remote to a Vizio TV, first, turn on the TV. Then, press and hold the "TV" button on the remote until the LED light changes from red to green, then release the button. Next, press and hold the "Setup" button until the LED turns green again, then release it. Finally, enter the code for Vizio TVs, which can typically be found in the remote's user manual or online; if entered correctly, the LED will turn off. Test the remote by trying to control the TV volume or power.
To program a DirecTV RC71 remote control to control the audio on a Vizio TV, first, turn on your Vizio TV. Press and hold the "Mute" and "Select" buttons on the remote until the green light blinks twice and then stays on. Next, enter the code for Vizio TVs, which may be 11756 or another code from the DirecTV remote code list. The green light will blink twice again if the code is accepted; if not, repeat the process with the next code until successful.
It depends on which word processing program you use. It is green in several though this is not universal.
A substance that turns universal indicator green is a base. Bases have pH levels higher than 7, which causes the universal indicator to turn green.
To program a channel changer for DirecTV, first, turn on your TV and the DirecTV receiver. Then, press and hold the "Mute" and "Select" buttons on the remote until the green light blinks twice and stays on. Next, enter the appropriate code for your TV brand (you can find a list of codes in the DirecTV remote manual), and if successful, the green light will blink and turn off. Finally, test the remote to ensure it can change channels and control the TV volume.
A neutral solution added to universal indicator will turn green.