Locate the Data Port under drivers side dashboard usually located to the right of steering column.
Insert keys in ignition and leave in the OFF position.
Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port terminals 1 and 4 with a suitable jumper wire, leave the jumper wire connected throughout the programming procedure. Make sure you know which terminals are 1 and 4.
Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. Note: The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode.
Press the LOCK button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.
Repeat step 5 with up to 4 remotes (including any existing remotes) within one minute. After completing each programming, the doors will lock and unlock once.
Disconnect the programming wire and remove the keys from the ignition.. Locate the Data Port under drivers side dashboard usually located to the right of steering column.
Insert keys in ignition and leave in the OFF position.
Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port terminals 1 and 4 with a suitable jumper wire, leave the jumper wire connected throughout the programming procedure. Make sure you know which terminals are 1 and 4.
Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. Note: The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode.
Press the LOCK button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.
Repeat step 5 with up to 4 remotes (including any existing remotes) within one minute. After completing each programming, the doors will lock and unlock once.
Disconnect the programming wire and remove the keys from the ignition..
i THINK IT MEANS THE CHIP IN YOUR KEY HAS BEEN DE-ACTIVATED. I'M TRYING TO RESEARCH HOW TO RE-ACTIVATE IT...
get the black wire and then the red wire and then pull the chip out of it and take the key and unlocked the dricer door
with a key
how to program a new key 2008 mitsubishi colt
If it has a cover on the key, yes. If it is a steel key no.
The immobilizer.
You can program a blank key for Mitsubishi Endeavor 2006 using Transponder Key Blank Fits.
Keylessride.com price is $18.99
How to program a Mitsubishi veranda KE key less clicker
The dealer scan tool is required to program a key on this Mitsubishi built car.
10mm
Try to put your car on the parking breakes.