Turn the ignition on and off 8 times (do not start the vehicle, just from the "lock" position, to the "on" position) on the 8th time, leave the key "on" and the doors will all unlock. When this happens, press both the lock and unlock button on your key FOB at the same time and presto, your FOB is programmed. If you are doing this for multiple FOB's, they need to be done at the same time.
Hope this helps.
Just to add to this because I read this and tried it. You must unlock the doors with the door switch first and then you MUST do the steps above in 10 seconds or less. The instructions are also in your owners manual under "remote".
**** SUPER EASY ****
1. Put all FOB's on one key - They do not all have to be the same FOB.
(I used one from the 2004 Explorer and one from a 1998 Explorer)
2. Get in car, shut door and UNLOCK DOORS WITH THE BUTTON ON THE DRIVERS SIDE DOOR.
3. Put Key in Ignition with ALL key FOBS hanging from it on ONE key Ring
4. TURN KEY TO "ON" Position and BACK TO "OFF" Position 8 Times ~> ON THE 8th TIME, LEAVE IT IN THE "ON" Position (Must be done within 10 seconds)
***The Doors will lock and unlock Automatically and the car will "DING" while you do the next step.
5. On each FOB, PUSH both the LOCK and UNLOCK buttons at the SAME TIME, ONE FOB AT A TIME.
6. Turn the key back to the off position and your DONE!
Where do I find the key less entry code on a 2001 Ford Expedition?
put the key in the ignition switch. turn it off/on off/on until you hear the doors lock or unlock. then hit the lock button on the key(s) or transmitter(s).
Each 2001 Ford Expedition with key less entry has it's own factory code
REMOTE CONTROL KEY COULD NOT WORK TO OPEN THE DOOR OR OTHER FUNCIIONS
Take the key to a ford dealership
Replace the lock cylinder
No.
In order to program a key on a 2004 VW Passat, you need to first put the existing key in the ignition.
You need to refer to the service manual to remove a 2000 Ford expedition XLTS key-less entry system.
It was an available option.
the dealer has to program the key, they will need the car and original key.
I have a 2008 Expedition Eddie B. Using the manual and the information center button and key you can program the doors to unlock when you open your door or park. Its in the manual.