I found these at: http://www.programyourremote.com/classified/BrowseMake.asp?cid=59 # Open the driver's door.
# Insert key into ignition.
# Turn the ignition switch to the ACC position and then to the LOCK position three times. (This step must be completed within 3 seconds - go as fast as yo can, or the system will not enter the programming mode.)
# Within 10 seconds, close and open the door two times.
# Turn the ignition switch to the ACC position and then to the LOCK position three times (again, do this within 3 seconds.)
# Within 10 seconds, close and open the door. Verify that the power door locks cycle once to confirm that the system is in programming mode.
# Within 20 seconds, press the LOCK button on the transmitter you are programming. Verify that the door locks cycle once.
# Within 20 seconds, press the UNLOCK button on the transmitter. Verify that the door locks cycle once to confirm that the system has accepted the transmitter's code.
# Repeat steps 7 and 8 for each transmitter to be added.
# Remove key from ignition. Disclaimer
i need motor of Isuzu axiom 2002
How do you put on a serpentine belt on a 2002 Isuzu axiom
inside the gas tank
Had the same problem with my 2003 Axiom... It was my intake gasket. 50 dollar gasket.... easy fix
Under the intake manifold, under the upper outlet.
On the very low rear of the engine block. It is difficult to get to.
under the passenger side.... behind glove box
5 Qt with filter change and 4.2 without
I heard someone comment that it has a "sealed" transmission, therefore, a dealer has to add fluid. I own a 2002 Isuzu axiom. they don't have a dipstick but they do have a holding tank on the right side you check and add fluid there.
take out light bulb in a dash
Its a so called maintanence free trans. I had to get my trans replaced at 68k.
There is no dipstick for the trans.