How do you program a keyless entry remote for a 2002 dodge neon?

Answer 1

=== === # Insert the key into the ignition switch, and turn the ignition switch to the RUN position without starting the vehicle (allow chimes to stop). # Using your old RKE transmitter, already programmed to the car, press and continuously hold down the UNLOCK button for 4-10 seconds. # Within the 4-10 second time range, continue to hold the UNLOCK button and press the PANIC button. Both buttons may then be released. Upon the PANIC button being depressed, the message for customer programming mode will be transmitted to the RKE module. # A chime will be heard to verify that the customer programming mode has been entered (allow 3 seconds to hear chimes). # Press and release any button on each transmitter that is to be programmed to the RKE module, including any transmitters which were previously programmed to the RKE module (with a maximum of four possible). After each transmitter is successfully programmed, a chime will be heard to verify that successful programming of the transmitter has occurred. # You may reprogram your old transmitter back into the car if it still works correctly. If not you may program up to 4 new RKEs. # After thirty seconds, or upon the ignition switch being turned OFF, the RKE module will exit programming mode.