If it's a N15 then you put the key in the ignition and switch it to "ON" and then "OFF" five times, or until the indicators flash. Then press the button on the remote. The lights should flash when it registers the remote. If you have more than one remote, just press the next button and it should register it as well.
Nissan pulsar n16 2000 speaker size
Can you please tell me where the location of the Crank Shaft Position Sensor is on a Nissan Pulsar N16 2000 model?
They have a chain.
How do u program a keyless remote for a 2000 GMC Yukon
I have a use remote that I need to program
how do i program keyless remote for 2000 Buick LeSabre
check
Get in and make sure all the doors are closed. Insert and remove the key 7 times in about 10 seconds, you have to take the key out all the way, both turn lights should blink. Then turn the key to ACC (first notch), push any button on the remote and the turn lights should blink again. Now just open a door to exit "setup mode" and test it. All the buttons on the remote should work now. The car can only remember 4 remotes at a time, so if it already has 4, one of them will be lost. If one of your remotes doesn't work after this then odds are it is the one that has been forgotten, just follow the steps again for the remote that doesn't work. This worked first time for me on my 2004 N16 MY04 Nissan Pulsar.
Go to dealer.
You will get a Keyless Entry Remote Fob Clicker for your 2000 Nissan Maxima SE.
main dealer diagnostic computer
Try this site www.programyourremote.com