0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Can you drive a mitsubishi galant without the front ecu?
No, the car will not start.
How hard to replace a pcm and ecu on a 2000 Mitsubishi Galant?
need diagram of how to install pcm in a 2000 mitsbishi galant
Will a 95 ecu on a Mitsubishi galant work right with a 94 engine 2.4?
If it is the same 2.4 engine
Where is the ecu on a 1999 Mitsubishi galant 2.0 liter gls located?
Is behind the front board, right behind the stereo
Where is the ecu on a 1999 2.4l galant?
ecu?
How do you reset the ECU on a Mitsubishi Galant 2003?
The best/easiest way is to pull the ground cable to the battery for 1 minute and re-connect.
What Mitsubishi ecu serial code?
Ecu rvr rs
Why might a 1989-1990 Mitsubishi Triton not start after changing the engine?
Did you also change out the ECU from the donor car? If not, that may be the problem.
Where is the ecu located in a 2002 galant?
Behind the blower motor
Where is the location of the distributor cap coil pack on a 2003 Mitsubishi Galant?
Lol my 200 galant doesn't have a distributor so I'm preatty sure urs doesn't your firing order is control by you ecu which gets it's imput on when to fire from the ckps...crankcase position sensor.
Mitsubishi Galant 2001 wiring diagram pictures?
A really good and comprehensive source for any vehicle's wiring diagram is a program call Mitchell On Demand. the program is rather expensive but many auto repair shops run this program. I would call around to some local shops and ask if they have this program and if they'd be willing to print you a hard copy. Keep in mind that Mitchell's wiring diagrams are extensive so be specific on what you need a diagram of. I recently needed a really good ECU to PCM diagram to connect a Greddy eManager to a 2000 Galant for a custom turbo project and I found what I needed on the Mitchell On Demand software. Mitsubishi was, of course, no help AT ALL.
What does an angle crank sensor do in a Mitsubishi Galant?
Crank angle sensor reads rpm and sends the signal to the ECU (computer) to aid in the calculation of engine rpm, ignition timing, fuel injection and crankshaft position.
