Q: How do I program the remote for keyless entry? a: Programming the keyless entry receiver will be required when you purcahse a replacement "FOB" or keyless entry remote unit. The keyless entry receiver is located behind the rear interior panel near the drivers seatbelt (drivers side). Here are the steps for programming your remote for keyless entry: 1. Remove the rear hatchback cover 2. Remove the rear seat: 1. Pull the two handles near the center of each seat section on the bottom portion of the seat 2. Lift the seat bottom upwards and set aside 3. Remove the two 12mm bolts at the base of the rear seatback on the drivers side 3. Remove the driver's side rear panel: 1. Remove the rearmost screw on the plastic strip that sits over the rocker panel 2. Remove the screw on the cover of the rear seatbelt retractor then remove the cover 3. Remove the screws holding the seatbelt harness from the frame. This can be tricky since there is little room to work with. Use a stubby screwdriver 4. The seatbelt itself does not need to be removed. You can just remove the harness and leave the seatbelt threaded thru the panel 4. Remove the screws closest to the rear of the car that are located on the plastic header and footer around the drivers doorframe. These typically overlap the rear panel by a small amount and may need to be loosened to move the rear panel 5. Behind the rear panel you should see a box in front of the rear speaker - this is the receiver unit 6. Remove the receiver from the car body 7. Find the switch labeled SET 1 - FIX - SET 2 and move the switch to either SET position. (the two SET positions are in case you have two transmitters with different codes) 8. Press any button on the remote transmitter 9. Move the switch back to the FIX position 10. Test the new remote transmitter 11. Reconnect everything making sure that the antenna connector is tightly connected to the receiver
Try this site: http://ebiz.netopia.com/pyr/door/.
The key fobs are not user programable. I have heard there are some locksmiths that can program the keys but I live is Texas and so far have found none to program any for my car. The only solution is to pay Mercedes to order a key from the Mercedes headquarters. If you choose this route make sure you have your title or registration along with the drivers license or they will not be able to order the key for u.
Need an advanced Scan Tool to perform this Necessary to take it to the dealer .
keys
No , I've changed my batterys in my key fobs a few times for my 1995 Explorer and never had a problem
ur ma
Most (if not all) key fobs can be recoded. You may want to inquire with your dealership or a good locksmith.
As much as you don't want to hear this, the only way to program a key less entry remote for a 2004 tibby is to take both key fobs and the car to the dealer. Don't shoot the messenger.
ur ma
I'm pretty sure the dealership has to program the fobs. I programmed my key using the instructions in the owner's manual. They're really simple if you follow them step-by-step, but I'm not sure if the instructions for the fob are in there.
Personalized key fobs can be bought online from some of the companies that trade through Amazon. They can also be bought from jewelers who also do engraving.
To program any kind of key fob you have to take it to a dealership.