1.Open the driver's door.
2.Insert key into ignition.
3.Turn the ignition switch to the ACC position and then to the LOCK position three times. (This step must be completed within 3 seconds - go as fast as yo can, or the system will not enter the programming mode.)
4.Within 10 seconds, close and open the door two times.
5.Turn the ignition switch to the ACC position and then to the LOCK position three times (again, do this within 3 seconds.)
6.Within 10 seconds, close and open the door. Verify that the power door locks cycle once to confirm that the system is in programming mode.
7.Within 20 seconds, press the LOCK button on the transmitter you are programming. Verify that the door locks cycle once.
8.Within 20 seconds, press the UNLOCK button on the transmitter. Verify that the door locks cycle once to confirm that the system has accepted the transmitter's code.
9.Repeat steps 7 and 8 for each transmitter to be added.
10.Remove key from ignition.
DID YOU TRY CHANGING OUT THE BATTERIES ON THE REMOTE??
bypass key on a trooper
Isuzu Trooper was created in 1981.
1999 Isuzu trooper
timing marks for 1996 Isuzu trooper
The 6VE1 3.5L V6 fitted to the Isuzu Trooper was manufactured in-house by Isuzu themselves
The trooper is made by Isuzu
Remove Camshaft fro isuzu trooper 1996
will a 3.2L 2000 Isuzu Trooper engine fit a 3.2L Isuzu rodeo transmission
The sister vehicle of the Isuzu Trooper is the Acura SLX
were is up shift relay on isuzu trooper automatic tramission & what does it do
How do you change the transmission fluid on a 2001 4x4 Isuzu trooper