Try this first. 1) lower the glove box. Fully lower it so you can see behind it. 2) you should see a grey 2 pin male connector back there. It will not be connected to a female, just dangling. 3) turn the ignition to the run position (don't start car) 4) short the two pins together (the door locks will cycle indicating programming mode) 5) press any button on the transmitter (door locks will cycle to acknowledge fob) 6) repeat step 5 for each transmitter 7) turn off ignition (door locks will cycle exiting programming mode) hope this helps.
Key Programming -- SpareCycle the ignition switch from OFF to RUN using a programmed key. After the anti-theft indicator goes off, remove the key.Within 15 seconds, insert a new encoded key into the ignition. wait till the anti-theft indicator goes off, turn key to Run/ START
How do you program a key fob to a 2003 Chevy Malibu
To program any kind of key fob you have to take it to a dealership.
How do I re program my key fob for renault laguna estate 1997?
You don't. Take the car and the new fob to a caddy dealer or a locksmith who has the equipment to program it.
A scan tool is required to program a fob on a 2006 Chrysler Town and Country.
how do i program keyless remote for 2000 Buick LeSabre
How do you program the remote key fob on a 2005 Chevy Malibu maxx
To add a new key fob, take the vehicle and the key fob to an authorized dealer. To re-program a key fob after replacing it's battery, open the key fob, then read and follow the instructions inside.
It is possible to program one key fob to use on two different cars. If the key fob uses a primitive fixed code system, programming two cars will not work.
http://www.ehow.com/how_7456283_program-key-fob-harley-davidson.html
The dealer scan tool is required.