1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down
until instructed to release in step 9.
4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by
door locks locking and unlocking automatically. (If locks do not cycle after you let go,
not before you let go of the unlock button, then the vehicle has not entered programming
mode and you must start procedure over. Remove key from ignition, open drivers door
and return to step 1 ). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and
unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
13. Test remote(s).
Wiki User
∙ 12y agoUrea -> 25-30 gm ammonia -> 0.7 gm
If you mean a GM vehicle that was built during the transition from OBD1 to OBD2, the answer is if it has a OBD port a scanner will work. GM MDI Tech 3 Interface is Dealer Level Diagnostic Tool for Multiple Brand vehicle: GM, Opel, Chevrolet, Saab from vipprogrammer.com
no & yes, yes it will bolt up to your engine, but to make it function, you will have to add a transmission computer to your ride. GM sells these for the conversion. Unfortunately, like everything else from GM it is expensive.The 4L60E is an electronoic computer controled transmission where as a 700R4, also known as a 4L60 ,uses the computer only for converter clutch lock up in the 92 model cars. I asume your car is a 92.
No.
the red coolant is only used in some GM models. you can use green only if it specifies that it can be used in GM vehicles.
You need a gm scanner to program a factory gm remote fobs.
The GM Family Legacy Program provides eligible children of certain deceased GM retirees and surviving spouses the opportunity to continue.
The GM Family First program is where family members of a GM employee can lease or purchase a new GM vehicle but get it at the price the employee pays. They even will let you combine the discount with most current offers as well!
This can only be done by a GM dealer.
Must be programmed by a GM dealer.
go to the gm dealer
You need to list the Year, Make & Model of the vehicle that you want to program it with.
how do you program keyless entry remote 98 GMC
you have to take it to the dealer.
You must take it to a locksmith that is capable of doing 12 or 13 GM cars, or a GM dealer because the ability to do it yourself has been removed by GM so they can charge you for it!
gd is graphics driver specifies which graphics driver to be used..... gm is graphics mode sets highest resolution for detected driver
Changing the computer will not change the engine timing.