How do you pull more string out of trimmer?

Answer 1

This is actually easier than it first appears.

# Line up the two arrows on the outer-spool and inner-reel. # ## This opens the channels from the feed-holes to the locking holes. # Remove any line left in the locking holes. # Feed new line into feed holes up though the channels until you have enough to place the ends of the lines into the locking holes. # Place line ends into the locking holes and pull tight. # Wind the inner-reel counter-clockwise, taking up the new line. Pause occasionally to pull each line tight. Leave about 4 inches at each end.

Answer 2

Once all the line is out, there should be a hole to run the line through after removing the spool. Once you take that out you need to run about 20 feet of line and rap it around the spool the direction the trimmer rotates. Then replace it as if it was a new spool of line.

Answer 3

There are two ways to change the string on a weed eater depending on what type of weed eater it is. First you will have to manually maneuver the appropriate amount of nylon string into the string cap at the head of the string trimmer. Or you can replace the entire head cap with a brand new spool of string. You will have to figure out what type of string trimmer you have and than decide which of the above you will need to do.

http:/www.weedwackerstore.com

Answer 4

Unplug the trimmer, turn the trimmer upside down so that the "string spindle" is up. With one hand pull gently on the string. With the other hand, press firmly on the spindle so as to push it into the head of the trimmer slightly. It should move a little and stop. This should release a small amount of string. Repeat this until you have enough string out.