0
Hi, I've recently replaced my stereo on the same model so I'm sure I can help.
It is easier to remove the full front facia unit inc heater controls etc.
Remove the glove box from the passenger side by applying gentle pressure to both sides as you pull down. This gives you access to the rear of the stereo.
You will see a bracket attached the the back of the stereo with a bolt, this bolt is to prevent the front facia unit from being removed from the car (anti theft). Remove the bolt.
Unclip the centre consoles (around handbrake, ash tray) this gives you access to two screws securing the bottom of the front facia unit which you need to remove.
With the screws removed pull the front facia unit forward until you have enough room to unclip each wiring harness attached to the facia unit.
Slide the front facia unit out and remove. You are now able to unscrew the stereo.
What else can I help you with?
How do you replace license plate light on a 2004 Mazda 6?
Remove the plastic cover on the outside and just pull the bulb out
Where would the knock sensor be located on a 2004 Mazda 6?
Where would the knock sensor be located on a 2004 mazda 6?
Will a 2004 Mazda 6 splash shield fit a 2005 Mazda 6?
yes
Does a 2005 Mazda 6 radio have RCA jacks?
No
Will a 2004 Mazda MPV motor go into a 2004 Mazda 6?
No, a 2004 Mazda MPV motor will not directly fit into a 2004 Mazda 6. The two vehicles have different engine designs and configurations, and their mount points and transmission compatibility differ. Additionally, the MPV is a minivan, while the Mazda 6 is a sedan, leading to further complications in installation and integration. It’s best to use an engine that is specifically designed for the Mazda 6.
How do you change headlight 2004 Mazda 6?
* *
What is the factory tire size 2004 Mazda 6?
The factory size tire for 2004 Mazda 6 2.3L engine in the U.S is P205/60R16
Which one is cylinder two in Mazda 6 2003?
where is located cylinder 2 in 2004 Mazda 6 , V6?
How many seats does a Mazda 6 2004 have?
5
How much does it cost to replace a heater core for a Mazda 6?
how much is to replace heater core on 2004 mazda 6
How to remove the led radio display 2005 Mazda 6?
To remove the LED radio display from a 2005 Mazda 6, first, disconnect the car battery to ensure safety. Then, use a trim removal tool to carefully pry off the trim surrounding the radio and climate controls. After removing the trim, unscrew the mounting screws holding the radio in place, and gently pull the radio unit out, disconnecting the wiring harness at the back. Be cautious not to damage any clips or wiring during the process.
How much horsepower does a 2004 mazda6 v6 have?
The 2004 Mazda 6 V6 has 220HP
