With the water supply turned on, and beginning at the highest point in the system, open all faucets slightly [to prevent a lot of splatter as pressurized air and water are expelled], and allow to run gently for a few minutes, or until each faucet has a gently and uniform water flow. Also, at or near end of process, flush all toilets two or three times. This should eliminate most, if not all, trapped air.
You should not have air in your pipes. Call a plumber.
Install a water hammer arrestor (air chamber)
Any break or leak on the suction side of your pump can cause air in the lines.
What type of water system - city supplied or private well? That is the foundation of your answer.
Air can get into pipes for many reasons. If you are on a well system you may be sucking air in from loose connections. On many municipal systems there are numerous leaks and each sucks in some air to the system.
The best way to purge water from pipes for the winter is to open the tap for about 24 hours. It is also a good idea to install frost proof hydrants on all outside outlets.
Singing water pipes can be caused by air that is trapped in the pipes. The air can cause a whistling or singing sound, or it can cause the pipes to knock or rattle.
Call your city hall or local water company and complain there is air in your water pipes.
You should not have air in your pipes. Call a plumber.
I see no reason why you would insulate them. When you close your pool for winter you will purge (empty) your pump and pipes. The water in the pool would freeze long before the water will in the pipes under ground.
Sometimes it's caused by air in the pipes.
Air accumulates in the water pipes after a water softener cycles because the water softener stops the flow of water during this time. This usually only takes 5 to 7 minutes. Air builds up when the pipes get empty.
Yes
They shake because, the water exerts pressure when running in the pipes
If you have a gas oven just turn on a couple of the burners until the flames regulate and seem to be burning without any air bursts coming through
If you have a water heater, particularly a gas one, you will need to purge your system if air gets in. This can happen when the water main is shut off, etc. A purge usually involves draining the water with a garden hose and then restarting the heater.The air bubble interferes with the heaters ability to interact properly with the heating coil.
in water distribution pipes,air valves are provided at