answersLogoWhite

0


Best Answer

With the car on jack stands, you have to remove the plug in the middle of the diff. Sometimes it is a bit hard, but it will come out. First check the level, with the plug out, oil should just drip out a little. If you need to add, use a small hand pump with the correct oil, say 80 or 90. If the plug does not want to come out, then heat has to be applied to get it going. A local garage can do this.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you put gear oil in the rear end of a 1997 ford crown Victoria?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does the 2001 Ford Crown Victoria have a shifting sensor on the transmission why wont it shift from second to drive Where do you start?

yes it does you don't need to be in 2nd gear anyways in a crown Victoria yes it does you don't need to be in 2nd gear anyways in a crown Victoria yes it does you don't need to be in 2nd gear anyways in a crown Victoria


Why does the parking brake disengage when you put your 1996 Ford Crown Victoria in drive?

I was looking at the 1996 Ford Crown Victoria Owner Guide and that's NORMAL The parking brake will release automatically when any forward gear is selected The parking brake will also not engage with the vehicle in any forward gear


How will you know if the neutral switch is bad in a 89 Ford Crown Victoria?

put it in drive gear and try and start it if it does start while in gear its bad if it doesnt its good.


Steering gear 1997 Ford T Bird?

Steering gear remove and replacement 1997 Ford Thunder Bird LX


What is the button on the end of the gear shift column in a 1003 crown Victoria?

I assume that is the button that allows you to turn off or turn on the overdrive for the transmission ( my Ford Explorer also has a button on the end of the gear shift lever for that purpose )


Why would a 1993 Ford Crown Victoria repeatedly have the brake lights stop working and also lose the ability to move the gear shift out of park?

check the sensor on the brake pedal.


Where is the overdrive dash light on a Ford Crown Victoria 2001?

On a 2001 Ford Crown Victoria : If you have the overdrive switched off using the transmission control switch on the end of your gear selector lever ( P R N etcetera ) You will see the " O/D OFF " light above and to the right of your speedometer and if you have the digital dash it will show " overdrive off " to the right of the speed indicator


How do you fix a broken speedometer on a 1999 Ford Crown Victoria Police Interceptor?

AnswerCan be tricky -may be dial-sensor at trans -or gear on shaft that turns sensor --even wiring or connection or the computer.


What might be reasons other than the speed sensor for the speedometer not working on a 1994 Ford Crown Victoria?

Speedometer cable (most common) Speedometer head Gear on transmission end of speedometer cable


What is the gear ratio of a stock 1997 ford ranger?

3.73


Why can't i put my 96 ford crown Victoria in gear after i start it up?

This answer may be obvious - Try pressing and holding the brake pedal down before attempting to shift out of Park. Hope this helps! Radioman


What is crown gear?

the crown gear is the largest gear in th differential on your vehicle to the sides of the crown gear are the planetary gears