String got under shaft
It is on the third string. You have to put 3 fingers down on the third string
you just put a pices of string under a hole
put the string on one end, put that end on top of your right foot put the bow behind your left calf, bend it around and attach the other end of the string.
You put your 3rd finger on the A string. It is an octave higher than the open D string.
There are two ways to play F7. 1: Bar the first fret of the guitar with your index finger. Place your middle finger on the G string (3rd string from the bottom) on the second fret. Then put your ring finger on the A string (2nd string from the top) on the 3rd fret. 2: Put your index finger on the B string (2nd string from the bottom) of the sixth fret. Middle finger goes on the D string (3rd string from the top) on the seventh fret. The ring finger is on the A string (2nd string from the top) of the eight fret with the pinky two strings below it on the G string (3rd string form the bottom) on the eight fret.
Unplug the weedeater from electrical source. Turn the weedeater upside down and remove the black knob on the bottom. If the black knob won't come off you can carefully use a large pipe wrench and turn it counter clockwise to loosen it. Be careful not to lose the slotted metal ring between the black knob and the trimmer spool. Remove the spool and clean it off. There is an arrow showing you where to insert the string. Start pushing the line into the spool going counter clock wise. Be sure to use only .065 ROUND string. Put the spool back on the spindle yellow side up. Hold the slotted metal ring with the slot facing up. Insert the string into the bottom of the ring and put the ring in the recessed circle on the spool, (yellow side). Pull the string over the slot and hold it there. Screw the black knob back onto the spindle, making sure the string is in the slot on the metal ring. Tighten the knob. You are now ready to go.
you would take off the cover and expose the recoil spring/shaft then detach the string and put the new one on
Sae 30w
There is a nut just above the large black plastic string holder. Hold the nut and unscrew the black plastic string holder (it is reverse threaded). Once the string holder is off, pull the button on the bottom string holder until it comes apart. Wind new string on and put it all back together as you pulled it apart.
with string and hair
I have a Kawasaki KTR27A string trimmer and I am very disappointed that Kawasaki's Owner's Manual did not include instructions on how to put new string in their trimmer. The challenge was getting the spool out. I finally figured out that you need to depress the center bumper and turn it clockwise. It will move easily to a stop, then turn it just a little harder and you will feel it move a little more. That releases it and you can pull it straight out. Then, just wrap new string on (direction is indicated on the spool), feed the two ends out through the holes in the head, and put the spool back in making sure not to have any of the new string underneath the spool. Then depress the bumper and turn in counter-clockwise to set it in place.
You Tube has videos for nearly anything. I have had great success as I own a 775r.
It is on the third string. You have to put 3 fingers down on the third string
is there a needle attached to the string if not there r other ways make a hole and put the string inside and go in and out and start moaning and giggiling
"Craftsman" is an entire range of tools and equipment and YOU haven't even said what the tool is !How do you expect a reply giving you a proper answer.
the dots are to show where to put your fingers when moving from string to string
you just put a pices of string under a hole