Want this question answered?
What is bussin? Bushings? If so, which bushings? Upper Control Arm (A-arm) Bushings? Sway bar bushings -- front or rear? Ya lost me bud, try to be a little more specific and maybe use a spell checker.
Four upper and four lower.
check the upper and lower trail end bushings
We changed both and the binding squeak stopped.
How much does it cost to replace the upper and lower control arm bushings on a 1998 Chevrolet S-10? Upper control arm bushings are quoted at about 1.9 hours fro each side. However, if both are done then 3.5 hours total. Lower control arm bushings are 1.9 hours for one side and 3.4 hours for both sides. Just apply your shop's labor rate to the above hours. Note: Not all mechanics use the same book to estimate time for reapirs. This data is provided by Alldata. Mitchell Brothers could be different, as could the other services. Note 2: Upper control arm bushings are far easier to replace than lower control arm bushings because they are far more readily accessibly.
four upper and four lower.
Rear upper & lower control arm bushings need to be replaced.
Extremely worn or loose shocks, bad upper or lower ball joints, worn control arm bushings.
There are 8 Bushings altogether for the subframe assembly on the intrepids. These kits range from 300.00-600.00. (and these are just the bushings) cheapest bushings I have come across are located at www.justforjeeps.com (not only jeep stuff here)
Your front controll arm bushings are shot, the 5 series uses an s arm rather than an upper and lower arm repair cost ranges between 1,000.00 and 1,600.00.
Could be a number of things upper and lower ball joints,wheel bearings,warped rotors,bent rim, tire out of balance etc.
Use a ball joint press. You can get one from Harbor Freight. You'll most likely need the accessory kit as well. You can use the press in different configuration to press the old bushings out, and the new bushings in. Even the front upper bushings in the axle can be pressed out, although it may be a little tricky setting up the ball joint press to do the job.