0
Unfortunately, you have to cut the old one out and weld a new one in. Unless you have experience with welding sheet metal, you should pay a body shop to do it.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you put rocker panel moldings on a 1967 Chevy Chevelle SS?
Those have to be cut out, and welded back in.
Can you put a 1970 Chevelle front clip on a 1972 Chevelle?
Yes.
What year was the Chevelle put into production?
1964
Will a 66 impala rear end fit a 66 Chevelle?
If you cut the housing down to fit the chevelle it will work but to just take and try to put it under the chevelle it's too long.
Where do you put oil in a rover 414?
in the rocker cover
Can you put a 1967 396 Chevelle engine in a 1971 350 Malibu?
sure can.
Who made a 468 cubic inch motor?
Chevy put one in the 1969 Chevelle.
Can you put a 1970 Chevelle front clip on a 1971 Chevelle?
YES it will bolt right on with no problems. You WILL need the headlight wiring harness from a '70 to accommodate the 4 headlight system though.
What bucket seats fit 1965 Chevelle?
Bucket seats out of a pontiac sunfire from the 90's will fit in a 60's chevelle. You might need to put risers on the mounting brackets.
How do you remove the rocker arm studs on an 85 Chevy 350?
There probably "pressed in" so take a couple of old nuts or balls from the rocker arm, put the nuts on the shaft, then put the rocker nut on and just tighten it up, it willl pull the shaft out of the head. Good Luck
What is a 454 big block motor?
a huge moter that they put in race car like the chevelle
How do you put oil in a Ford Fiesta?
little breather on top of the rocker cover, pull it off and put the oil in.
