answersLogoWhite

0

Most lawnmower/garden supply stores have, or can get, a control cable kit for your lawn mower. The brackets that hold the cable have clamps that secure it. Cheap ones have cable ties. At the handle there is a place to put the throttle control. Before you go to get the new cable check out your mower. On the engine there is the carburetor and the cable ends up there. It is usually on the side of the mower and can be moved manually. There is a screw that holds the cable there. Figure out what tools it is going to take. Ask when you pick up your kit if any special tools are needed. Also ask for advice based on what you know about the mower and the condition of the old throttle assembly. Be careful. It really should not be very hard to do. Some places will do it for you while you wait. Just wheel it in.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Fiat punto 1.2 speedgear engine runs ok but when gearbox put in drive there is no power to the wheels and engine just revs What is the problem?

Low cvt oil level or selector control cable


Car stalls when put in gear?

if its a manual then it could be three things, clutch cable or throttle cable, or IAC (idle air control valve) but if its an automatic it could be throttle cable or IAC.


Will service engine light come on after you remove battery cable then put it back on?

It shouldn't.It shouldn't.


How do you disconnect the check engine light on a 2001 dodge caravan?

Take the - battery cable off and put it back on.


How do I reset check engine light on a Toyota Tacoma 2002?

take off the positive cable on the bettery and turn on the key switch for 5 minuts then put battery cable back on and the check engine light should be off


Put infrequent in an interesting sentence?

It is most infrequent that I have friends yelling about bat-shaped lawnmowers in my room at one in the morning.


How do you reset or turn off the check engine light on a 1997 GMC Jimmy?

just remove the battery cable for about 5min then put it back. that should reset the check engine light.


How do you turn off the check engine light in 93 Mitsubishi expo?

Pull the negative battery cable for 2 minutes. Then put it back on.


Why does your car stall when you put heat on?

There is a problem with the engine control system. It needs to be repaired by a knowledgeable person.


Can you put a tranny from a 1990 silverado with a 350 in a 2000 K2500 with a 350 engine both are 4X4's?

NO engine management needs input from trans its electric controls . 90 trans is tv cable no feedback could cause trouble plus no where to hook up tv cable


Where does the negative battery cable ground to for a 1997 Chevy blazer?

It should be bolted to the engine block anywhere you can put it. Make sure it is on cast iron.


Does gasoline go bad?

Yes, gasoline starts to go bad when it is about 1 month old. After 6 months you should not burn it in an engine unless you have put a fuel stabilizer in it. In that case it will be usable for about 8 months. This is also important with small gasoline engines on lawnmowers for example. Bad or old gasoline can damage a small engine very easily.