NO engine management needs input from trans its electric controls . 90 trans is tv cable no feedback could cause trouble plus no where to hook up tv cable
no
Bolted to the rear of the engine. Normally it is on the drivers side, but not always.
no, very different
A stock 1990 Chevy silverado with a 350 cubic inch, 5.7 liter V8 engine produces 210 horsepower.
It is in the exhaust pipe where it comes off of the engine on the passanger side.
NO. The heads and intake are different. The intire fuel system is different. Fuel pump is different. The intire engine wiring harness is different. But the engine will set right in there and bolt up, But NOTHING will work.
Yes it will.
Yes, any 2.8 will fit in a transformer.
The cylinder heads are diffrent. Intake from 1998 truck will not bolt up to 1990 heads.
3.73
It is screewed into the side of the engine block just in the front of the starter. Right side/passenger side.
In the tranny. You have to remove the tranny pan to get to it. Hope this helps.