Want this question answered?
The gasket on an Oldsmobile Bravada is changed by removing the retaining bolts, taking off the cover, and peeling the gasket off. The surface is then cleaned and a new gasket put in place.
Push both buttons at the same time, it will reset to zero.
Start engine, put in neutral and allow it to warm up. On the passenger side of the firewall there is a transmission dipstick that says "trans lock" pull it out, clean it, put in back in and check for level. You can also check it cold but its best to check warm and in neutral.
No difference at all mechanically. Gmc and Chevy used some different trim pieces on the outside. If you are looking for parts the small pickup in each brand will also interchange. I also believe that Oldsmobile put out a version of that same body. The Oldsmobile version is called the Bravada
you maybe blew the motor have u tried ur spark plugs distributor cap and all that
Yes it will an Oldsmobile bravada rear end is 52 1/8 inches backing plate to backing plate a two wheel drive blazer or s10 rear end is 47 3/8 inches from backing plate to backing plate so depending on what wheels you want to run I put a bravada rearend in my s10 and I'm running a 15x8 weld prostars with a 5 1/2 inch back spacing but I think you can squeeze a 15x10 with a 6 1/2 inch or 7 1/2 inch back spacing also make sure you keep the wheel cylinders for the bravada as the s10 wheel cylinder won't work but the rest of the brakes will
If you put your car info into: http://car-part.com/ It will list related models that fit your car.
My best placement would be somewhere next to you house were you will not have to walk back and forth from the grill to the house a hundred times to get what you need.
You put it on a grill and then you flip it and you know have grilled pear
How do I take the back panel off
put it on the grill
He put it on a grill and ceerked it.