Want this question answered?
lol! On my 1997 Rodeo (v6, 3.2l) it is in the back -- the manifold must be removed to access it. lol! On my 1997 Rodeo (v6, 3.2l) it is in the back -- the manifold must be removed to access it.
make sure the camshaft sprocket timing mark is aligned with the upper back cover and cranksaft sprocket timing marks align the crank mark with the cast-in mark on the front seal retainer.
on the passenger side of the engine about midway back
The EGR valve on a 95 Isuzu Rodeo is located on the back top of the engine. It resembles a cylinder.
loosen the 7/8 main nut on the tensioner then back off the adjuster 12mm till there is enough slack to remove the belt
It is on the oil pan towards the back.
Please show picture of how to put on belt
The AC low pressure valve on a 1996 Isuzu Rodeo is located in the back of the engine compartment. The valve is on the larger of the two hoses that run from the evaporator to the compressor.
Align camshaft sprocket ( white dot ) with white arrow on top of back part of timing cover, and white dot on crankshaft sprocket with cast in timing mark on seal retainer ( aluminum casting below bolt at 12 oclock ) the key in the crankshaft will face up for tdc and align with timing mark.
It is really easy. First take off the tailgate and the glass lift hatch. Then you are done.
You can find it about midways back under the vehicle, middle left hand side.
It is located under intake manifold towards the back. It is above the starter.