0
on the 1987 model which I believe is the same operation, you would push the button next to the parking brake lever on the left lever down when lever is fully released. then while squeezing the lever, shift 1 position down from nuetral.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can you take struts and springs from a 1989 Honda prelude and put them in to a 1989 Honda accord?
No, they are different.
How do you put a 1993 Honda fourtrax in reverse?
on the left hand grip is a red button push it in and apply the left brake,push your foot shifter down and you will be in reverse.
Why would a 1989 Honda Civic DX 1.t automatic make a clunk when put in reverse if it is cold but work OK when warmed up?
The fluid is thicker when cold so you get a harsher engagement when you put it in reverse. Also, part of that problem is that the transmission is wearing out but it's highly unlikely that you need a rebuild very soon. Check the transmission mount to make sure it's not broken because if it is, it'll torque upwards and bang when it's put in reverse. You can check that by putting it in reverse with your foot on the brake and tapping the gas pedal.
How do you put Honda 420 rancher in reverse?
You press the button on the left hand brake that has an red R on it then you down shift.
How do you put a Honda trx300 fourtrax in reverse?
theres a little red button on the left handle bar push that down then pull that brake lever in and shift down untill it goes into reverse
Why would a 1989 LeSabre not go into reverse sometimes have to put the car in neutral push the accelerator then put it in reverse and it will work how can this be fixed?
add atf. take to local oil change place have them drain and replace filter and fluid.
1998 Honda accord and you put it in R it don't go anywhere and it sounds like rears griding but when I put it in drive it works fine?
Seek professional help as your reverse gear is defective.
How do you put the 2003 Honda Recon ES in reverse?
You simply push the red R button down on the left brake handle pull brake in and hit the down shift button and your in reverse... hope this helps ...C.M.
How do you put a Honda 300 four wheeler in reverse?
Honda 300 ES reverse procedure: 1. Push handlebar mounted reverse button 2. Pull in clutch 3. Blip throttle to prevent stalling if cold. 4. Reach right hand down to lower left side of engine and pull up lever. 5. Release clutch and apply throttle.
How do you put 2008 Honda 420 rancher in reverse?
push the red button on left brake lever before pulling it back, once the lever is pulled then pucs the bottom shift button and it will drop outta neutral into reverse.
How do you put a 1985 Honda big red three wheeler into reverse?
Let it idle then slide lever back into neutral then into reverse rev up and it should be in reverse
What could be wrong if your 1991 automatic Honda Civic goes forward but engine will only rev when put in reverse?
could be either transmission shift linkage not engaging reverse ( stops at neutral ) worn joint connectors sometimes cause this. or reverse clutches or gears bad inside transmission.
