Pick up the floor piece, the third seat gets exposed. Fold the seat back and you have the third seat.
You need to raise the liftgate, then remove the liftgate upper trim panel. Remove the panel by carefully pulling straight out, it's only held in by spring clips. You'll now be able to access the bulb holders. Remove the bulb holders by rotating them 1/4 turn clockwise. The bulbs pull straight out from the holders. Put everything back together in reverse.
If you want to raise a sagging floor, you can put a piece of plywood on the floor. You can then add new flooring over the piece of plywood.
Lift the carpeting in the "way-back" cargo area and you will see a panel inset as part of the floor. Raise this panel (actually converts to a small camping table). If they are still with the vehicle, you will see the jacking tools underneath this panel.
Lift the rug in the "way-back" cargo area and you will see a panel built into the floor. raise the panel and you will find all the tire-changing necessities located there. If you don't have one I STRONGLY suggest you invest in an Owners Manual.
with cememt
to raise the qur'an off the floor
If you go in the trunk and raise the floor carpet, you find an access panel right behind the back seats. I believe it has about ten screw. Open it up and you will see it.
raise and elevate
Have professionals come jack it up.
I had to to take the door panel off remove the window motor raise the window then put the motor back on
leg raise is lie on the floor put hands behind your lower back raise your leg 6 inches from the groung for 5 seconds
Support the engine of the Durango with a jack, using a board on top. One at a time, remove the bolts from a motor mount. Raise the engine slightly, and remove the mount. Replace the mount and bolt it in. Repeat on the other side.